- 博客(0)
- 资源 (1)
空空如也
基恩士条码枪
基恩士条码枪设置,加载直接使用COGNEX
DM3V Verify SOP-Woodland
Online V1.0
2 | Confidential © 2013 Cognex Corporation
硬件清单-Hardware list
DM3V Verifier
1 根 light cable
Ethernet Stand cable
Power cable
红色低角度环光-Low
Angle Red Ring Light
2X远心镜头
2X Telecentric Lens
3 | Confidential © 2013 Cognex Corporation
连接相机,镜头和线缆 Connecting camera, lens and cables
连接相机和镜头,旋转到位。连接三条电缆到相机上,如上图,从上
到下分别是以太网电缆、光源电缆和供电电缆。
Connect the lens to the camera firm. Connect 3 cables to the camera
shown as the above image. From the top to bottom, they are Ethernet
cable, lighting cable and power supply cable.
4 | Confidential © 2013 Cognex Corporation
固定镜头光圈- Fix lens aperture
置 固定镜头光圈到指定位置 - Fix lens aperture to required position
并锁紧光圈锁 - Tightening aperture lock
5 | Confidential © 2013 Cognex Corporation
调整相机和光源的高度 Adjust camera and light height
安装相机和光源时,保证它
们要同轴(+/-3mm) ,并且和
码的高度相同。当拍照时,
代码应该在图像的较中心的
位置。
Keep the camera and the light
are coaxial (+/-3mm) when
mounting on the machine.
Their center should be at the
same height as the code.
When capture an image, the
code should be around the
image center.
6 | Confidential © 2013 Cognex Corporation
调整相机和光源工作距离 Adjust camera and light
working distance
镜头右端面距离代码表面约为75mm, , 光源右端面距离产品约为10mm 。 。
如上图所示 。这些距离会由支架来保证
The distance between lens right end face and code surface is 75mm. The
distance between light right end face and code surface is 10mm. Shown as
the above image. Bracket designed has taken this in the design
10mm
75mm
7 | Confidential © 2013 Cognex Corporation
供电电缆 Power supply cable
8 | Confidential © 2013 Cognex Corporation
连接相机电源和RS232通讯 Connect the power and
RS232 connection
TxD
RxD
24V DC
GND
24V
0V
红(Red)
黑(Black)
棕(Brown)
白/黄(White/Yellow)
按照下图来连接电源和RS232 通讯。
Connect the power and RS232 communication according to below diagram.
9 | Confidential © 2013 Cognex Corporation
软件安装-Software Installation
求 系统需求 System Requirements
The PC you use must meet the minimum hardware and software
requirements. At least 600MB free disk spac
2017-12-08
空空如也
TA创建的收藏夹 TA关注的收藏夹
TA关注的人