- 博客(0)
- 资源 (31)
- 收藏
- 关注
RSS订阅000_PythonInstallAndAbstract.docx
记录Python的学习过程，与大家分享，同时也是自己成长的一个见证
记录过程也是知识库的建立过程，后面我会持续记录自己的学习过程
2019-09-23
proteus与keil联动仿真软件滤波
仿真信号：直流信号（1.5v）+50hz交流信号（200mv自己可以在proteus中修改）
keil工程已经给出，自己把dll文件装上后，就可以联动仿真了
在调试中，可以同过产看最大值与最小值的差值（differ）产看干扰信号被滤掉多少
经证明，当软件滤波采样频率定位1khz时可以把200mv 50hz的干扰信号滤到10mv以内。
程序是我自己写的，有几个宏定义，看清楚了，有助于理解程序
2012-12-10
C8051F04X-UART0
This program demonstrates how to configure the C8051F040 to write to and read from the UART interface
2012-11-01
C8051F04X-SPI0-EEPROM
This program accesses a SPI EEPROM using polled mode access. The 'F04x MCU is configured in 4-wire Single Master Mode, and the EEPROM is the only slave device connected to the SPI bus
2012-11-01
C8051F04X-SMBUS-EEPROM
This example demonstrates how the C8051F04x SMBus interface can communicate with a 256 byte I2C Serial EEPROM (Microchip 24LC02B
2012-11-01
C8051F04X-DAC
This program outputs sine and cosine waveforms using the hardware DACson the C8051F04x microcontroller. The waveforms are output on pins DAC0 and DAC1.
2012-11-01
C8051F04X-Comparator0
This software shows the necessary configuration to use Comparator0 as a reset source.
2012-11-01
C8051F040-CAN1
CAN1.c and CAN2.c are a simple example of configuring a CAN network to transmit and receive data on a CAN network, and how to move information to and from CAN RAM message objects.
2012-11-01
c8051f04x-ADC0
This program measures the voltage on an external ADC input and prints the result to a terminal window via the UART.
2012-11-01
使用单片机普通IO口模拟串口的三种方法
随着单片机的使用日益频繁，用其作前置机进行采集和通信也常见于各种应用，一般是利用前置
机采集各种终端数据后进行处理、存储，再主动或被动上报给管理站。这种情况下下，采集会需
2011-08-05
空空如也
TA创建的收藏夹 TA关注的收藏夹
TA关注的人